Replacing car brake pads is a relatively simple but careful operation, the following are the steps to safely replace car brake pads:
1. Prepare tools and spare parts: First, prepare new brake pads, wrenches, jacks, safety supports, lubricating oil and other tools and spare parts.
2. Parking and preparation: Park the car on a solid and flat ground, pull the brake, and open the hood. Wait a moment to let the wheels get cold. But down. Prepare tools and spare parts.
3. Positioning brake pads: Find the position of the brake pads according to the vehicle manual, usually at the brake device under the wheel.
4. Use a jack to lift the car: Place the jack on the appropriate support point of the vehicle chassis, slowly lift the car up, and then support the body with a safety support frame to ensure that the body is stable.
5. Take off the tire: Use a wrench to unscrew the tire, take off the tire and put it next to it for easier access to the brake device.
6. Remove the brake pads: Remove the screws that fix the brake pads and remove the old brake pads. Be careful not to stain or damage the brakes.
7. Install the new brake pads: Install the new brake pads on the brake device and fix them with screws. Apply a little lubricating oil to reduce friction between the brake pads and the brake device.
8. Put the tire back: Install the tire back in place and tighten the screws. Then lower the jack slowly and remove the support frame.
9. Check and test: check whether the brake pads are firmly installed and whether the tires are tight. Start the engine and press the brake pedal several times to test whether the braking effect is normal.
10. Clean tools and inspection: Clean the work area and tools to ensure that no tools are left under the vehicle. Double check the brake system to make sure there are no problems.
Post time: Dec-16-2024