The installation time of brake pads varies with factors such as vehicle model, working skills and installation conditions. Typically, technicians can replace brake pads in 30 minutes to 2 hours, but the specific time depends on whether additional repair work or replacement of other parts is required. The following are the steps and precautions for the replacement of general automotive brake pads:
Preparation: Make sure the vehicle is parked on a flat surface, pull the handbrake and put the vehicle in park or low gear. Open the hood of the vehicle above the front wheels for subsequent work.
Remove the old brake pads: unscrew the tire and remove the tire. Use a wrench to remove the brake pad fixing bolt and remove the old brake pad. Check the wear of brake pads to ensure that the appropriate new brake pads are selected during replacement.
Install new brake pads: Install the new brake pads into the brake caliper and hold them in place by fixing bolts. Ensure that the brake pads and brake discs are fully fitted during installation, and there will be no loosening or friction. A good situation.
Put the tire back on: Reinstall the tire on the axle and tighten the screws one by one to ensure that it is firmly fixed. When tightening the tire screws, please be careful to follow the cross order to avoid uneven tightening causing balance problems.
Test the brake effect: After completing the installation, start the vehicle and slowly press the brake pedal to check whether the brake pads are working normally. It can carry out short distance test and repeatedly step on the brake to ensure that the braking effect meets the requirements.
In general, the installation time of brake pads is not long, but technicians are required to operate and ensure that the installation is in place. If you are not familiar with car repair or lack relevant experience, it is recommended to go to the car repair shop or vehicle repair for replacement to ensure your driving safety.
Post time: Nov-18-2024